ELICA ELN630SS Manuel télécharger pdf (Page 7)

Installation

Mounting the duct cover bracket

Fixed height duct cover

• From the horizontal line traced in the previous section, trace a

horizontal parallel line as shown below.

• Center the bracket in the top horizontal line and align it with the

centerline, as described in the following drawing.

Centerline

Bracket line

Horizontal straight pencil marked line

Desired installation height

Mark screw holes locations in the wall.

IMPORTANT. Check to be sure that holes locations are

leveled, and correctly centered by the vertical centerline.

Drill

⁄16” pilot holes in the marked locations.

Install wall fastener anchors.

Drive wood 2 - 5 x 45 mm screws, by hand, into the fasteners to allow

anchors to expand. Remove screws.

Secure the bracket to the wall with wood screws and/or fasteners.

Install framing for hood support

• If drywall is present, mark the screw hole locations.

• Cut away enough drywall to expose 2 vertical studs at the holes

location indicated by the template.

Install two horizontal supports at least 4 x 2” between two wall

studs at the bottom and upper mounting holes installation location.

• The horizontal support must be ush with the room side of the

studs.

• Use cleats behind both sides of the support to secure to wall studs.

• Reinstalll drywall and renish

IMPORTANT- Framing must be capable of supporting 100 lbs.

8½” min. opening for ductwork

View from rear

cleats

1” x 6” min

Mounting Support

Centerline of

installation

space

Mounting the hood

WARNING: 2 people are required to lift and position the hood onto the

mounting screws.

• Place the template on the wall along the horizontal line, make sure

the template is leveled and centered with the centerline.

• Mark upper screw holes locations in the wall.

• IMPORTANT. Check to be sure that hole locations are leveled and

correctly centered by the vertical centerline.

• Drive 2 - 5 x 45 mm upper wood screws by hand. Leave ¼ “ of

distance between the screw head and the wall.

¼”

(6.4mm)

• Remove the grease lter and mount the hood onto the upper

screws.

NOTE: The screws provided for mounting this hood must be fastened

into solid wood, do not fasten into sheet rock only.

Complete preparation

1. Determine and make all necessary cuts in the wall for the vent

system. Install the vent system before installing the range hood.

See the “Venting Requirements” section.

2. Determine the location where the power supply cable will be run

through the wall.

3. Drill a 1¼” (3.2 cm) hole at this location.

4. Pull enough power supply cable through the wall to allow for easy

connection to the terminal box.

5. Install the 8” (20.3 cm) round vent transition with damper to top

of the range hood using 4 - 3.5 x 9.5 mm screws.

1 2 3 4 5 6 7 8 9 10 11 12 ... 31 32

Commentaires sur ces manuels

Pas de commentaire

ELICA ELN630SS Manuel Page 7

Commentaires sur ces manuels

Produits connexes et manuels pour Hottes de cuisine ELICA ELN630SS