ELICA ELN630SS Manuel Page 10

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 32
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 9
10
Range hood use
The range hood is designed to remove smoke, cooking vapors and
odors from the cooktop area. For best results, start the hood before
cooking and allow it to operate several minutes after the cooking is
complete to clear all smoke and odors from the kitchen.
The hood controls are located on the center side of the range hood.
A B
A. Lamps knob
B. Blower knob
Operating the lamps
1. Turn the light switch to the “LOW” position to turn the range hood
lights On.
2. Turn the light switch to the “HI” position to turn the range hood
lights at its higher intensity.
3. Turn the light switch to the “OFF” position to turn the range hood
lights Off.
Operating the blower
1. Turn the blower switch at “1” to turn the range hood on.
2. Turn the blower switch to the desired speed position.
3. Turn the blower switch to the “HI” position to turn the range hood
on High.
4. Turn the blower switch to the “OFF” position to turn the range
hood blower Off.
Range hood care
Replacing an Halogen Lamp
Turn off the range hood and allow the halogen lamp to cool. To avoid
damage or decreasing the life of the new lamp, do not touch lamp
with bare ngers. Replace lamp, using tissue or wearing cotton gloves
to handle lamp. If new lights do not operate, make sure the lamps are
inserted correctly before calling service.
1. Disconnect power.
2. Use a at-blade screwdriver and gently pry the light cover loose.
3. Remove the lamp and replace with a 120-volt, 40-watt
maximum, halogen lamp made for a G-9 base.
4. Replace the light cover.
5. Reconnect power.
6. Turn the light switch to the “OFF” position to turn the range hood
lights Off.
Cleaning
Exterior surfaces:
To avoid damage to the exterior surface, do not use steel wool or
soap-lled scouring pads. Rub in direction of the grain line to avoid
scratching the surface.
Always wipe dry to avoid water marks.
Stainless Steel Cleaner and Polish.
Mild liquid detergent and water.
Wipe with damp soft cloth or nonabrasive sponge, then rinse
with clean water and wipe dry.
Metal Filters and Drip Trays:
1. Use 2 hands to remove lters.
2. Grasp lter handles, pull toward the front of range hood and pull
down on the rear handle to remove. Repeat for each lter.
A
A. Grease lter
3. Remove grease drip tray.
A
A. Drip tray
4. Wash metal lters and grease trays as needed in dishwasher or
hot detergent solution to clean.
5. Replace grease drip tray.
6. Reinstall lters, grasp lter handles and place front edge of lter
into the hood.
7. Push up on the back handle and set rear of lter into the drip tray
to secure. Repeat for each lter.
A
A. Grease lter
Vue de la page 9
1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 31 32

Commentaires sur ces manuels

Pas de commentaire