ELICA ETW536SS Manuel d'utilisateur télécharger pdf (Page 8)

Installation

Installation - Ductless (Recirculating) version

1. Pre-installation calculations

C = Counter Height (36" standard)

H = Prefered Height of Hood

Bottom above counter

L = Chimney Structure Height, your installation.

L = X-Y-H+1" 3/16

a) Select a hood preference height H that is comfortable for

the user.

b) Calculate Hood height your installation L = X-Y-H+1"

3/16 .

c) Confirm that H is within the range of min to max H found

for your model (See “Dimensions and clearances”

paragraph). If not adjust your installation.

2. Preparation of mounting surface

Installing supports above ceiling drywall.

Note: Take into consideration the hood depth; the hood

could be much deeper than the cooktop.

a. Mark center lines of cooktop or range on ceiling above.

Use centerlines marked on ceiling to position the

mounting template.

Note location of hood front (that indicated with a printed

arrow), side, and mounting holes indicated on template.

Note: Remember that printed arrow on template

corresponds to front of the hood and consequently to

side where control panels will be located at the end of

installation)

b. Remove and save template. Cut and remove ceiling

drywall. Install suitable length 2" x 4" lumber between

joists to provide support bracket mounting points as

shown above. Use template for dimensions and

required clearance.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Pas de commentaire

ELICA ETW536SS Manuel d'utilisateur Page 8