ELICA ELN630SS Manuel d'installation télécharger pdf (Page 8)

Install Range Hood

1. Using 2 or more people, hang the range hood on the the wall

by placing the slotted holes in the range hood back over the 2

screws mounted to the wood support mounted to the wall.

A. Installation screws (2 - 5 x 45 mm)

B. Mounting holes

C. Lower installation screws (2 - 5 x 45 mm)

2. Push the range hood up into the narrow slots, align the bottom of

the hood to the horizontal line, level the hood, and tighten the 2

mounting screws.

3. Mark 2 lower mounting hole locations. Drill

⁄8” pilot holes if the

holes are located into wood. If holes are not located into wood,

remove the hood and drill two

⁄8” pilot holes and insert 10 x 50

mm wall anchors. Remount the hood, level, and tighten the upper

screws. Install 2 - 5 x 45 mm screws and tighten (C)..

4. Connect vent system to hood. Seal all joints with clamps.

5. If your installation uses the optional duct cover, mount it to

the top of the range hood following the instructions supplied

with the duct cover.

Mounting the duct cover

1. Position the duct cover over the mounted hood.

2. Position the top of the duct over the duct mounting bracket.

3. Secure the top of the duct with 2 - 4.2 x 8 mm assembly screws

provided.

4. Secure the lower duct cover to the range hood canopy using

2 - 4.2 x 8 mm screws.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 31 32

Pas de commentaire

ELICA ELN630SS Manuel d'installation Page 8